What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 13:39

It also is a device that limits the change in current flow.
a photo is worth a thousand words.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Do guys ever want to suck a dick even though they are straight?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is where the MOV conducts again, and dissipated the energy.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This device then solves the entire problem.
For this case there are devices called Metal oxide varistors (MOV).
Barnstars:
[old diagram got deleted by accident]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Why do I smell bad even though I have good hygiene?
First Sentence:
The bolt then partially travels down the line to your home.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Human-sized Labubu doll sells for more than $150,000 - BBC
Can the fuse protect the electronic devices from lightning instead of a surge protector.
He then asserts :
These devices are installed between the “hot” and “neutral” and protective ground.
I post the exact comment here.
eight
He then describes Rainy Season and Lightning.
Does having the wrong address on my car insurance invalidate my policy?
Because the load is inductive, the current lags the voltage.(by a bit).
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
the problem then depends on "how fast does the fuse operate?".
This is where this question deviates from being a 'generic' question, and becomes more specific.
So, the voltage could go up to 500 volts, and the fuse will not open up.
What is lightning?
What makes someone feel "rich enough" in different societies?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
There are three different concepts here that are getting confused.
At least they know the answer if they wanted it.
What is the best/cute/funny/playful chat/conversation between brother and sister?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
The MOV will conduct when the voltage exceeds 50% of line voltage.
But it can get overloaded, and no longer works.
Have you ever accidentally found out that you were about to be fired?
An AC voltage/ current source, and an ac inductive load.
At one ohm, the resistor has a maximum of 1 watt power.
One
Why are people nowadays so into anal sex?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
what exactly is a ‘surge’ protector?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Here is a simplified AC power diagram.
There are two important concepts here.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Upvotes:
He then describes the function of a fuse.
but this device (an Inductor) … impedes the rapid changes in the current.
But… the neutral is now “floating” because of the 1 ohm resistance.
but I think this circuit , shows a few more pieces.
This one hit behind the barn.
Edit 2024–10.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
These are simplified answers to the original question, and does not change anything I wrote above.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
What does a fuse do?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–16 [ OO OLAOYE OYEBODE ]
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
A circuit breaker is similar, but is resettable.
A fuse is a non-resetable over current circuit protector.
This is 'the assistant's answer'
Now when you have a certain ac resistance, then a current flows in a loop.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
The other is “what does a “fuse” do?”
so, what happens?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
It seems Mohan does not understand the difference between a comment and an Answer.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
(Dc diagram shown, AC is similar).
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–10[John johnson John Johnson ]
[image of Common-mode choke]
The third is lightning and “how it gets conducted into a home.”
nine
In schematic diagrams this is the symbol for a fuse: